VDO Radio Module RM 8204 Manual de Serviço descarregar pdf (Página 108)

Print-quality troubleshooting tools

Repetitive image defects ruler

If the product output has a consistent, repetitive defect, then use the table in this section to determine

which part needs to be cleaned or replaced based on the measured distance between the repetitions of

the defect.

NOTE: Spots can be dark or white (dropouts), bands can be all shapes and sizes.

Component Distance between defects (mm) Type of defects

Developing roller

About 22 Dropouts

Dark, sharp bands

Primary charging roller

About 26 Dropouts

RS roller About 29 Dropouts

Secondary transfer roller About 47 Dropouts

Dirt on the back of page

Fuser film About 58 Dropouts

Dirt on page

Loose toner

Pressure roller About 63 Dirt on page

Dirt on the back of page

Loose toner

ITB drive roller About 76 Spots

Photosensitive drum

About 95 Dropouts

Dirt on page

The primary charging roller, photosensitive drum, and developing drum cannot be cleaned. If these rollers cause a repetitive

defect, replace the corresponding cartridge, either the imaging-drum cartridge, or developing cartridge.

Calibrate the product

1. Press the Setup button to open the menus.

2. Use the arrow buttons to scroll to the System Setup menu, and then press the OK button.

3. Use the arrow buttons to scroll to the Print Quality menu, and then press the OK button.

4. Use the arrow buttons to scroll to the Calibrate Color item, and then press the OK button.

5. Use the arrow buttons to scroll to the Calibrate Now option, and then press the OK button.

90 Chapter 2 Solve problems ENWW

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 169 170

Sem comentários

VDO Radio Module RM 8204 Manual de Serviço Página 108